"96 2.3 Head
#1
10-16-2007, 12:06 PM
"96 2.3 Head
Getting ready to install a Racer Walsh header, manufacter is Pace Setter, in my '96 Ford Ranger XLT.
My question is, does the '96 2.3 head, daul plugstill have the EGRports just below the mainexhaust port?? This Header has the plumbing already installed for it, the collection is between #3-#4 primary tubes of the header port plate.
Oh yeah I had a local shopR&R my degraded stock exhaust system to a Magnaflow cat & sigal / dual muffler it's a 2.5 pipe. I replaced the O2 sensors also. I thought the O2s were suppose installed on top of the pipestraight up-down ?? These guys installed them in in the side of the pipe ?? Dunno??
My question is, does the '96 2.3 head, daul plugstill have the EGRports just below the mainexhaust port?? This Header has the plumbing already installed for it, the collection is between #3-#4 primary tubes of the header port plate.
Oh yeah I had a local shopR&R my degraded stock exhaust system to a Magnaflow cat & sigal / dual muffler it's a 2.5 pipe. I replaced the O2 sensors also. I thought the O2s were suppose installed on top of the pipestraight up-down ?? These guys installed them in in the side of the pipe ?? Dunno??
Thread
Thread Starter
Forum
Replies
Last Post
