Heater blower only working on high
#1
Heater blower only working on high
I purchased a resistor pack and went to install it and lo and behold there wasn't one installed from the factory. The spot was ther but it wasn't even cut out. I see a round gray unit with a 4 wire plug located by the blower motor.#056700-5260 with terminal 3 and 4 show a open switch and 1 and 2 look like a resistor diagram. Does this take the place of the resistor pack? If not what else would control the speed. Any help would be appreciated. Thanks. Bob
Thread
Thread Starter
Forum
Replies
Last Post