94 E150 steering box to flex connector
Login  | |
|
94 E150 steering box to flex connector - 11/29/2006 9:27:25 PM
|
|
|
strider380
Posts: 18
Score: 0
Joined: 5/3/2006
Status: offline
|
I just pulled of my steering gear box for a rebuild as the pitman seal was leaking a quart every few days. Everything went smooth but now I can't get the input shaft on the box to connect to the clamp on the U-joint on the steering shaft (intermediate shaft??). It is toed with a flat spot both on the inside of the clamp and the outside of the shaft. I managed to get it in with the help of a friend, but think its only halfway in. I got one bolt through the frame into the gear box. The other 2 bolts will not line up though, most likeley because the shaft from the gear box is not all the way inserted in the clamp on the u joint. I remember it being alot more difficult to pull off then when it went on. I am sure it has to go on further. Any tips to pressing the input shaft on the gearbox back into place on the steering shaft? I tried tapping it with a hammer but didn't want to hit it too hard. Anything I'm missing? Please help, I need to see how good of a job I did on the rebuild!!!! All tips appreciated!!!!!
|
|
|
|
|
|
|
Printable Version
. I am having a problem with the box now though. Check new thread.
