RE: Clunk , binding pop noise in front (4x4 F250 Diesel 2002)

Ford Forum Ford Classifieds Photo Gallery Member List Search Ford Recalls Contact FF Sponsors
Ford News Ford Lineup Forum FAQ Calendars Ford TSB's Register Login

RE: Clunk , binding pop noise in front (4x4 F250 Diesel 2002)

Printable Version

Ford Forum >> Ford Trucks, Ford Vans & Ford SUV's >> Ford F-250 & Ford F-350 >> RE: Clunk , binding pop noise in front (4x4 F250 Diesel 2002)

Page: << < prev 1 [2]

Message

<< Older Topic Newer Topic >>

RE: Clunk , binding pop noise in front (4x4 F250 Diesel... - 2/1/2007 1:22:25 PM

Hayapower

Posts: 1945
Score: 0
Joined: 7/22/2006
Status: online

The hub has a thin o ring running around it's circumference for sealing.. No seals needed.. Remove the old hub, make sure the o ring sealing surface is clean (rotor/hub portion) , lightly lube the o ring on the new hub and install.. Make sure the snap ring seats all the way.. Sometimes the old hub may need a little 'help' to move, and you may need some soft jaw pliers ect with some rocking/pulling to get it to release.. Souldn't take more that minutes to do...

_____________________________

05 F250 C/C FX4 6.0
1969 Firebird Trans Am
2003 Hayabusa GSXR1300

(in reply to black95gt)

Post #: 11

RE: Clunk , binding pop noise in front (4x4 F250 Diesel... - 2/1/2007 2:06:50 PM

black95gt

Posts: 12
Score: 0
Joined: 1/26/2007
Status: offline

alright cool. Thanks for your help

(in reply to Hayapower)

Post #: 12

RE: Clunk , binding pop noise in front (4x4 F250 Diesel... - 5/7/2007 12:07:57 AM

hntmstr

Posts: 1
Score: 0
Joined: 5/7/2007
Status: offline

Check your cab mounts. Sometimes you can replace your cabmounts and the noise will go away. I have replaced mine a few times and the last time it did not go away. I had to make some shims a place them between the mount and the body and have not had another problem since. Good luck

(in reply to gmathews4761)

Post #: 13

RE: Clunk , binding pop noise in front (4x4 F250 Diesel... - 5/10/2007 12:25:30 AM

enibum

Posts: 45
Score: 0
Joined: 9/18/2006
Status: offline

I had this on my 2001 Excursion and had it fixed. I have it again on the other side now. It is your sway bar bracket bushing. At the end of your sway bar there is a bracket that the end of the bar is mounted to. The bracket has a round rubber bushing in it that the bar sticks through and has a nut on the end. The rubber bushing goes bad and allows the bar to pop when enough force is put on it, like when you make the truck twist, like when you are backing out of your driveway. You can see the bracket hanging down just behind the front wheels. Hope this helps.

(in reply to hntmstr)

Post #: 14