Freestar analog dash clock (Full Version)

Ford >> Ford Trucks, Ford Vans & Ford SUV's >> Ford Freestar

Freestar analog dash clock

  

Jakers -> Freestar analog dash clock (6/20/2007 10:03:18 AM)

Just bought a 2004 Freestar Sport and love it but like to install the analog clock in the center of the dash. Bought the clock and the center vent assymbly but wander if anybody did the same and would like to know if the wiring for this clock is in the wiring bundle behind the dash. Can anybody shed some light on this? TIA Jake

  
Jakers -> RE: Freestar analog dash clock (6/22/2007 1:43:05 PM)

This is more or less a reply to my own enquiry as I since found out I also need the wiring for this clock and have ordered it from Ford.

Jakers -> RE: Freestar analog dash clock (6/29/2007 11:54:15 AM)

Got the clock and wiring installed and IMHO adds a bit of pizazz to the interior.
Too bad I did get no help from this forum.

Hayapower -> RE: Freestar analog dash clock (6/29/2007 1:46:30 PM)

Thanks for the update.. Post a pic if you can....

Jakers -> RE: Freestar analog dash clock (7/2/2007 7:35:02 AM)

Here a picture of the finished installation.

[image]local://upfiles/11432/AA1637D7DC234C49AD268D6BD3729BA6.jpg[/image]

jcasaccio -> RE: Freestar analog dash clock (7/15/2008 12:12:33 PM)

The bulb on my clock has just burned out.   To get the clock out of the dash, does it just slide out from the plastic (the whole chrome bezel and clock) or is it hard to remove the clock?

jcasaccio -> RE: Freestar analog dash clock (9/4/2008 6:59:44 PM)

Ok Jakers.  First let me say thanks for replying to my question I sent you a short time ago.  I am trying to replace the clock light bulb.  My problem (still) is that I can''t get the darn vent panel off, without thinking I''ll break it.  I tried screwdrivers to pry off and try to lift past the plastic tabs holding it in.  I have not been successful.  I do all the maintenance on my cars and this one has me miffed/scared of breaking it.   What tools did you use to get that thing off?  I also tried a 2" putty knife, but still no go.   Any other advice is appreciated.   I am not trying to be annoying, but the burnt bulb is so annoying.....

Regards,
Jack

  

Page: [1]

Return to Ford Forum home page or view the Full Version of this page.