460 swap mounts

Ford Forum Ford Classifieds Photo Gallery Member List Search Ford Recalls Contact FF Sponsors
Ford News Ford Lineup Forum FAQ Calendars Ford TSB's Register Login

460 swap mounts

Printable Version

Ford Forums >> Past Ford Models >> Fairlane/Falcon/Galaxie/Gran Torino >> 460 swap mounts

Page: [1]

Message

<< Older Topic Newer Topic >>

460 swap mounts - 7/20/2007 6:06:12 PM

dirigo

Posts: 1
Score: 0
Joined: 7/20/2007
Status: offline

Where can I get mounts to stuff a 460 into my 302 69 Fairlane?

Post #: 1

RE: 460 swap mounts - 7/25/2007 8:21:59 AM

goinstrong

Posts: 914
Score: 0
Joined: 2/24/2007
Status: offline

You could try making a set by using parts of both mounts (assuming you have any fancy of machining parts). But even so - keep in mind you will need to change things in the front end a little bit (like springs) to make the steering and alignment corrected to the increased weight (should there be any). Also - make sure your type frame can handle the increased torque output without incident or need for modification. Plus putting a big block where a small block was requires a check of firewall clearance if you're switching from a C-4 to C-6 transmission. This will tell you if you need to make the transmission and engine mounts to fit it. Many times a standard transmission will fit in easier than an automatic as far as firewall (but then there's the clutch pedal issue in a changeover). If you have time an easy way to check for specialty mounts you would need is to go on a search engine and use broad, one or two word searches like specialty mounts or changeover mounts or Ford engine transplant , etc.

(in reply to dirigo)

Post #: 2