Ford Forum  
Ford Forum   Ford Classifieds   Photo Gallery   Member List   Search   Ford Recalls   Contact FF   Sponsors
  Ford News   Ford Lineup   Forum FAQ   Calendars   Ford TSB's   Register   Login  

95 7.3 DI. po267,po268po475p1263 codes

  Printable Version
Ford Forum >> Ford Trucks, Ford Vans & Ford SUV's >> Ford F-250 & Ford F-350 >> 95 7.3 DI. po267,po268po475p1263 codes Page: [1]
Login
Message << Older Topic   Newer Topic >>
95 7.3 DI. po267,po268po475p1263 codes - 11/5/2007 8:59:17 PM   
wrenchman68


Posts: 6
Score: 0
Joined: 11/5/2007
Status: offline
 fixed thank you

< Message edited by wrenchman68 -- 11/18/2007 8:42:01 AM >


_____________________________

wrenchman68
Post #: 1
RE: 95 7.3 DI.Hard start, missing x4 cyl ,ck eng - 11/6/2007 8:24:39 AM   
david paul

 

Posts: 217
Score: 0
Joined: 8/31/2007
Status: offline
sounds like injection system or computer as the injection system is computerized i would say you would have to go to the dealer or a diesel injection shop

_____________________________

DAVID PAUL

(in reply to wrenchman68)
Post #: 2
RE: 95 7.3 DI.Hard start, missing x4 cyl ,ck eng - 11/6/2007 8:47:27 AM   
wrenchman68


Posts: 6
Score: 0
Joined: 11/5/2007
Status: offline
Could bad fuel cause this, as sometimes it will start and run ok for 1 min then lope ,chech eng lite, sounds like one side of the eng is comeing apart, tail pipe smoke looks lean then rich and so on then slowly dies.
P.S. my old man just filled it up ?

(in reply to david paul)
Post #: 3
RE: 95 7.3 DI.Hard start, missing x4 cyl ,ck eng - 11/15/2007 9:36:15 AM   
BRETM

 

Official Site Sponsor
Posts: 257
Score: 0
Joined: 11/9/2007
Status: offline
Bad fuel will not cause the codes to appear. P0267 is cyl #3 circuit high. P0268 #3 circuit low. P1263 is #3 high to low side open. I would disconnect valve cover connector and inspect to see if wiring is burned, or may have to remove valve cover to inspect wiring under there.

_____________________________


www.discountedgenuinefordparts.com



(in reply to wrenchman68)
Post #: 4
RE: 95 7.3 DI.Hard start, missing x4 cyl ,ck eng - 11/17/2007 12:17:54 PM   
wrenchman68


Posts: 6
Score: 0
Joined: 11/5/2007
Status: offline
 thank you !
r&r valve cover and there it was , burnt wireing for #3 inj. YOU THE MAN!

(in reply to BRETM)
Post #: 5
Login OR Register now to post a reply to this forum topic.
Page:   [1]

 
Ford >> Ford Trucks, Ford Vans & Ford SUV's >> Ford F-250 & Ford F-350
Jump to:

Featured Sponsors
Advertising Info

Top 10 Posters
hayapower2082
goinstrong943
techmanbd877
94 4x4 range834
cctxfish735
ramrod48608
use common s540
bullitt94475
wheelsup68431
mulletman343

New Vendors
AMSOIL - Performance Oil Technology

Ford Forum .com is not affiliated with or endorsed by Ford Motor Company.