Seat belt light and noise

Ford Forum Ford Classifieds Photo Gallery Member List Search Ford Recalls Contact FF Sponsors
Ford News Ford Lineup Forum FAQ Calendars Ford TSB's Register Login

Seat belt light and noise

Printable Version

Ford >> Ford Trucks, Ford Vans & Ford SUV's >> Ford F-150 >> Seat belt light and noise

Page: [1]

Message

<< Older Topic Newer Topic >>

Seat belt light and noise - 11/14/2007 5:27:07 PM

hillbillydeluxe

Posts: 7
Score: 0
Joined: 11/7/2007
Status: offline

Does any one know the code sequence or what needs to be done to get the seat belt to stop alarming all the time ? Its on a 2003 F150

< Message edited by hillbillydeluxe -- 11/14/2007 8:32:54 PM >

Post #: 1

RE: Seat belt light and noise - 11/14/2007 7:14:41 PM

techmanbd

Posts: 877
Score: 0
Joined: 8/31/2005
Status: offline

Are you talking when you don't use it? I remember in the work trucks I use to use at one company had F150's and all we did is when we got into the truck started it, and it was dinging, was push in the release button of the belt latch.

_____________________________

2006 Mustang GT Tungston - Hurst Comp/pro shifter
Infinity KAPPA682.7CF, BasslinkII sub and 4SC Module

1990 Ranger 4.0

2004 Triumph Daytona 955i - Yellow

(in reply to hillbillydeluxe)

Post #: 2

RE: Seat belt light and noise - 11/14/2007 8:34:57 PM

hillbillydeluxe

Posts: 7
Score: 0
Joined: 11/7/2007
Status: offline

Yes thats correct when the truck is being used and the seat belt is not.

(in reply to techmanbd)

Post #: 3

RE: Seat belt light and noise - 11/14/2007 8:58:46 PM

Hayapower

Posts: 2082
Score: 0
Joined: 7/22/2006
Status: offline

Belt Minder Deactivating/Activating

Preparation

Before deactivating/activating the belt minder, set the parking brake.

2. Place gearshift in P (Park) (automatic transmission) or the neutral position (manual transmission).

3. Place the ignition switch in the OFF position.

4. Close all the vehicle doors.

5. Unbuckle the driver's safety belt.

6. Place the parklamps/headlamps switch in the OFF position. (If vehicle is equipped with Autolamps, this will not affect the procedure.)

Deactivating/Activating

1. Turn the ignition switch to the RUN position. (Do not start the engine.)
2. Wait until the safety belt warning lamp turns off (approximately one to two minutes).

3. NOTE: Steps 3 through 5 must be completed within 60 seconds or the procedure must be repeated.

Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled. This portion of the procedure can be done before or during belt minder warning activation.

4. Turn the parklamps/headlamps on then off.

5. Buckle then unbuckle the safety belt three times ending with the safety belt unbuckled. After this step the safety belt warning lamp will be illuminated for three seconds.

6. Within seven seconds of the safety belt warning lamp turning off, buckle then unbuckle the safety belt. This will enable the belt minder if disabled or disable belt minder is enabled.

7. The following sequence of events confirm the belt minder is enabled:

flashing of the safety belt warning belt lamp four times per second for three seconds

three seconds with the safety belt lamp off

flashing the safety belt lamp four times per second for three seconds again

8. The safety belt lamp flashing four times per second for three seconds provides confirmation of belt minder disabled.

9. After confirmation, the deactivation/activation procedure is complete.

< Message edited by Hayapower -- 11/14/2007 9:10:06 PM >

_____________________________

05 F250 C/C FX4 6.0
1969 Firebird Trans Am
2003 Hayabusa GSXR1300

(in reply to hillbillydeluxe)

Post #: 4

RE: Seat belt light and noise - 11/14/2007 9:03:27 PM

hillbillydeluxe

Posts: 7
Score: 0
Joined: 11/7/2007
Status: offline

That is very in depth i will try tomorrow and let you know Thanks for the help.

(in reply to Hayapower)

Post #: 5

RE: Seat belt light and noise - 11/15/2007 7:39:23 PM

hillbillydeluxe

Posts: 7
Score: 0
Joined: 11/7/2007
Status: offline

Worked great thanks for the help

(in reply to hillbillydeluxe)

Post #: 6

RE: Seat belt light and noise - 11/15/2007 8:06:31 PM

Hayapower

Posts: 2082
Score: 0
Joined: 7/22/2006
Status: offline

Glad you got it squared away...

_____________________________

05 F250 C/C FX4 6.0
1969 Firebird Trans Am
2003 Hayabusa GSXR1300

(in reply to hillbillydeluxe)

Post #: 7

RE: Seat belt light and noise - 11/16/2007 11:53:14 AM

Bullitt94

Posts: 475
Score: 0
Joined: 8/18/2005
Status: offline

That's good stuff. I may have just pulled the fuse...

_____________________________

1994 Ford Mustang GT
1990 Ford F-150
2001 Lincoln LS V8
1970 Ford Bronco
2006 Harley-Davidson Sportster Custom
1990 Ford Bronco II

If you don''t already own a Ford (or Ford owned product), get one.

(in reply to Hayapower)

Post #: 8