ford 500 strange dash problems

Ford Forum Ford Classifieds Photo Gallery Member List Search Ford Recalls Contact FF Sponsors
Ford News Ford Lineup Forum FAQ Calendars Ford TSB's Register Login

ford 500 strange dash problems

Printable Version

Ford Forum >> Ford Cars >> Ford Five Hundred >> ford 500 strange dash problems

Page: [1]

Message

<< Older Topic Newer Topic >>

ford 500 strange dash problems - 12/6/2007 4:25:30 PM

tootie

Posts: 1
Joined: 12/6/2007
Status: offline

I have a 05 500. Today it had strange dash problems today. All the gauges flicked on and off for a short period of time. I first thought the car had stalled because the gauges went dead like the engine had cut, but it was running just fine. It only did this when the car was somewhat cold.

Post #: 1

RE: ford 500 strange dash problems - 12/9/2007 12:29:06 AM

s0981

Posts: 2
Joined: 12/20/2006
Status: offline

Take your car to the dealer, I had the same exact problem about a year ago and they fixed it.

This is the TSB I took with me for the dealer.

TSB 06-17-9
09/04/06
INTERMITTENT INSTRUMENT CLUSTER
OPERATION - INCLUDING GAUGES SWEEP/RESET - MULTIPLE WARNING LIGHTS ILLUMINATED AND/OR REVERSE LIGHTS STAY ON - VEHICLES BUILT BEFORE 2/17/2006
FORD:
2005-2006 Five Hundred, Freestyle

MERCURY:
2005-2006 Montego

This article supersedes TSB 06-6-2 to update the Service Procedure.
ISSUE
Some 2005-2006 Freestyle/Five Hundred/Montego vehicles built before 02/17/2006 may exhibit intermittent instrument cluster concerns with one of the following symptoms:

Very temporary intermittant condition at which time the Instrument Cluster pointers will intermittently "home" randomly after the ignition switch is in the run position. This is when all pointers travel to the low end of gauge travel, jitter for two to four seconds, and then recover. This condition may be more likely to occur as the vehicle drives over rough road surfaces.
During hard fault or prolonged intermittant condition, most functionality of the cluster will cease operation as soon as the issue is present, including all gages becoming inoperative.
While the fault exists, multiple warning lights will be illuminated, Cluster High Speed Controller Area Network (CAN) or Medium Speed CAN network communication with other module(s) will be inoperative, and reverse lights will stay on. If the fault discontinues, the tachometer and speedometer gauges will sweep and then reset. Look for U1900 diagnostic trouble code (DTC) in other electronic modules, as well as P0462/P2067 in the powertrain control module (PCM).
These symptoms could be the result of a defective solder joint on the printed circuit board in the instrument cluster.

Good Luck

_____________________________

Scott

(in reply to tootie)

Post #: 2