Ford F150 Full Size Van

Ford Forum Ford Classifieds Photo Gallery Member List Search Ford Recalls Contact FF Sponsors
Ford News Ford Lineup Forum FAQ Calendars Ford TSB's Register Login

Ford F150 Full Size Van

Printable Version

Ford Forums >> Ford Trucks, Ford Vans & Ford SUV's >> Ford Econoline E Series >> Ford F150 Full Size Van

Page: [1]

Message

<< Older Topic Newer Topic >>

Ford F150 Full Size Van - 5/15/2008 6:21:59 PM

rtb20926

Posts: 2
Score: 0
Joined: 5/15/2008
Status: offline

2003 - F150 - Full Size Van

Anyone know how to disable the seat belt alert. You know the chime that alerts you every 30 seconds it seems, that your seat belt isn't latched. I would love to disable it!

Thanks!

Post #: 1

RE: Ford F150 Full Size Van - 5/15/2008 6:25:29 PM

rtb20926

Posts: 2
Score: 0
Joined: 5/15/2008
Status: offline

Sorry it's an E 150

(in reply to rtb20926)

Post #: 2

RE: Ford F150 Full Size Van - 5/15/2008 7:32:08 PM

Hayapower

Posts: 1828
Score: 0
Joined: 7/22/2006
Status: offline

Guessing the 'F series' was a typo..

Here's the info for the deactivation/activation..

Belt Minder Deactivating/Activating

Preparation

Before deactivating/activating the belt minder, set the parking brake.

Place gearshift in P (Park) (automatic transmission) or the neutral position (manual transmission).

Place the ignition switch in the OFF position.

Close all the vehicle doors.

Unbuckle the driver safety belt

Place the parklamps/headlamps switch in the OFF position.
Deactivating/Activating

Turn the ignition switch to the RUN position. (Do not start the engine.)

Wait until the safety belt warning lamp turns off (approximately one to two minutes).

NOTE: Steps 3 through 5 must be completed within 60 seconds or the procedure must be repeated.Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled. This portion of the procedure can be done before or during belt minder warning activation.

Turn the parklamps/headlamps on then off.

Buckle then unbuckle the safety belt three times ending with the safety belt unbuckled. After this step the safety belt warning lamp will be illuminated for three seconds.

Within seven seconds of the safety belt warning lamp turning off, buckle then unbuckle the safety belt. This will enable the belt minder if disabled or disable the belt minder if enabled.

The following sequence of events confirm the belt minder is enabled:

flashing of the safety belt warning belt lamp four times per second for three seconds

three seconds with the safety belt lamp off

flashing the safety belt lamp four times per second for three seconds again

The safety belt lamp flashing four times per second for three seconds provides confirmation of belt minder disabled.

After confirmation, the deactivation/activation procedure is complete.

_____________________________

05 F250 C/C FX4 6.0
1969 Firebird Trans Am
2003 Hayabusa GSXR1300

(in reply to rtb20926)

Post #: 3