no heat in 2000 windstar 3.8

Ford Forum Ford Classifieds Photo Gallery Member List Search Ford Recalls Contact FF Sponsors
Ford News Ford Lineup Forum FAQ Calendars Ford TSB's Register Login

no heat in 2000 windstar 3.8

Printable Version

Ford Forums >> General Ford Forums >> General Tech >> no heat in 2000 windstar 3.8

Page: [1]

Message

<< Older Topic Newer Topic >>

no heat in 2000 windstar 3.8 - 10/30/2005 4:06:27 PM

vivalasvegas777

Posts: 2
Score: 0
Joined: 10/30/2005
Status: offline

I have a 2000 windstar 3.8. heater and a/c does not work. blower works fine except for a clicking sound every 2/3 seconds depending on where the slider is pulled to on the temperature control panel. i changed the thermostat today and it is still not working. i'm no expert by any means on vehicle repair and was LUCKY to find the thermostat and replace it but it seems to me that there is no pressure getting into the hose that leads from the radiator to the thermostat. when the car is running the hose is empty and "sqeezable" no pressure in it. after running the car for 5 minutes the resevoir didnt seem to have any pressure either. maybe i'm far off but it seems like that hose should be filled if i'm trying to heat the car. any help before the ice and snow hits would be appreciated. thanks!

just noticed on another auto forum that someone had issue with an actuator?? does this sound right? can i find this at my local adv. auto parts store or is this something i need to get somewhere else. any idea on cost?

HELP I'M TOO POOR FOR COSTLY REPAIRS!!

< Message edited by vivalasvegas777 -- 10/30/2005 5:33:24 PM >

Post #: 1

RE: no heat in 2000 windstar 3.8 - 11/1/2005 9:07:25 PM

vivalasvegas777

Posts: 2
Score: 0
Joined: 10/30/2005
Status: offline

fyi... heat is WORKING!!!! the problem was the actuator. it is located behind the radio/heating,air controls. it is no bigger than a pack of cigs and it is white. you can't miss it when you take out the radio. it's the only white part. kinda hard to get to but well worth the effort. was told it would have cost me about 1k to take it in for repair. thank god i found a post on another automotive repair site. same issues, same problem, same fix for about 60 bucks and 2 hours of work. the part was 53.00 and then i bought a tool for 4 bucks at walmart to get the radio out. was told i could use a coathanger. i tried this.. it took me longer to figure out the coathanger idea wasn't working than it took me to just go to walmart and buy the right tool. i posted a couple pics for everyone to see what the part looked like just in case. and i hope you can benefit from what i've learned.. saved me hundred and hundreds. oh yeah.. i also opened up the bad actuator to find out what went wrong.. suprise suprise... plastic gears and parts. my kids toys look better engineered.
until next repair.............

Attachment (1)

(in reply to vivalasvegas777)

Post #: 2

RE: no heat in 2000 windstar 3.8 - 12/19/2006 11:11:09 AM

daves_99sel

Posts: 1
Score: 0
Joined: 12/19/2006
Status: offline

this same part has failed in my 99 windstar: also on the passenger side of the heater case a round vacume control with plastic arm ( # F58H-19A580-AC ) has broken and is hanging. Ford tells me the case will need replaced due to broken blend door parts. Has anyone had a problem like this?

(in reply to vivalasvegas777)

Post #: 3