Is it hard to change a clutch in '97 ranger

Ford Forum Ford Classifieds Photo Gallery Member List Search Ford Recalls Contact FF Sponsors
Ford News Ford Lineup Forum FAQ Calendars Ford TSB's Register Login

Is it hard to change a clutch in '97 ranger

Printable Version

Ford Forum >> Ford Trucks, Ford Vans & Ford SUV's >> Ford Ranger >> Is it hard to change a clutch in '97 ranger

Page: [1]

Message

<< Older Topic Newer Topic >>

Is it hard to change a clutch in '97 ranger - 11/23/2004 11:13:19 PM

josser

Posts: 143
Score: 0
Joined: 11/19/2004
Status: offline

The same Ranger with the 401 engine code needs a new clutch. How hard is it to change the clutch or better, getting the tranny out on one of these trucks? It is a 3.0 v-6 4X2. Time is not problem, I have air tools, tranny jacks, the clutch. I changed the clutch before on my '66 Falcon with its original 283, then with a 289 and now with a 351C. the ranger seems to have many little pieces parts that the Falcon just doesn't have.

Post #: 1

RE: Is it hard to change a clutch in '97 ranger - 2/10/2005 11:59:22 PM

jackson_turney

Posts: 16
Score: 0
Joined: 2/10/2005
Status: offline

Try changing the clutch on a 4WD tranny. (keep in mind it came factory with a borg and warner)
Now thats a pain in the @$$

(in reply to josser)

Post #: 2

RE: Is it hard to change a clutch in '97 ranger - 2/14/2005 4:22:27 PM

cctxfish

Posts: 735
Score: 0
Joined: 1/12/2005
Status: offline

josser, I don't think you'll have any problems. Just keep track of all the parts you remove and how the go. And of course don't forget to properly line up the clutch plate.

(in reply to jackson_turney)

Post #: 3

RE: Is it hard to change a clutch in '97 ranger - 2/24/2005 9:16:57 PM

josser

Posts: 143
Score: 0
Joined: 11/19/2004
Status: offline

thanks guys, it was not as hard as it looked! loosened the transmission and slid it back 6 or so inches, took the old clutch out and noticed leaking slave cylinder, replaced all parts clean flywheel and pressure plate with emery cloth and put it all back together, not to mention bleeding the system and it works fine.

(in reply to cctxfish)

Post #: 4

RE: Is it hard to change a clutch in '97 ranger - 4/4/2005 1:18:57 PM

jackson_turney

Posts: 16
Score: 0
Joined: 2/10/2005
Status: offline

I have a 97 3.0l B3000 4X4 which I wont go near. However yours being a 2wheel drive it shouldnt be to hard.

(in reply to josser)

Post #: 5