2008 f150 in limp mode
#1
2008 f150 in limp mode
I have a 2008 f150 4.6 v8 xlt with the 4R75E A/T transmission. Left my buddies house and the truck was in limp mode. No warning or anything. So i have read a few threads on here and tried several of the suggestions.
No engine light on
i don't have a code reader that can read transmission codes (yet)
Checked the fuses all good
So i replaced the tranny fluid as well as the dual shift solenoid it seemed to be weak when i was applying a voltage to it.
The other sensor tested ok i put air thru it as i was applying the voltage to make sure it opened and closed.
The only one i didn't try was the Automatic Transmission Control Solenoid
I replaced the tps sensor as well. i thought it was an 08 why not since that could have been a possible problem.
I see the 12volt at the connector into the transmission.
I reviewed the wiring harness as best as i can seen no broken wires.
where does the grounds for the solenoid come from?
Any input would be great
thanks in advance
No engine light on
i don't have a code reader that can read transmission codes (yet)
Checked the fuses all good
So i replaced the tranny fluid as well as the dual shift solenoid it seemed to be weak when i was applying a voltage to it.
The other sensor tested ok i put air thru it as i was applying the voltage to make sure it opened and closed.
The only one i didn't try was the Automatic Transmission Control Solenoid
I replaced the tps sensor as well. i thought it was an 08 why not since that could have been a possible problem.
I see the 12volt at the connector into the transmission.
I reviewed the wiring harness as best as i can seen no broken wires.
where does the grounds for the solenoid come from?
Any input would be great
thanks in advance
Thread
Thread Starter
Forum
Replies
Last Post
paul4ut
General Tech
1
05-19-2012 06:54 PM