Hello ,

I have a 1994 Ford F-150 , 5.0 with automatic transmission, that will not drive when in drive or reverse .
The transmission shifts into gears just fine .
The transmission was replaced along with the torque converter and the issue still persist.

 

More detailed information is needed.

 

Raski, When the transmission is placed in any gear besides park it acts like its in neutral .
I checked the fluid levels to ensure it was at the correct fill level.
What other information would be useful ?

 

Did you happen to leave the old rubber mounting seal in it
It happens then sucks air

 

Frank where would the mounting seal be located ?
When the transmission came in , it had plugs where the fluid lines , dip stick and output shaft.

 

It would be under the pan where ther filter pushes up into the valve body
I didn't read your post close enough
I doubt if a good rebuilder would make that mistake
Sorry

 

Does this truck by any chance have 4 wheel drive?

 

Did you call the rebuilder and ask them how to adjust the range sensor?

 

hanky the vehicle is not equipped with 4 wheel drive.

 

No , I have not contacted them about the range sensor.
The shifts appear to be recognized correctly. The truck will only start in Park or Neutral.
When placed in Reverse the reverse lights come on.