'89 Bronco II oil pressure sending unit location
Thread Starter
Joined: Sep 2006
Posts: 2
'89 Bronco II oil pressure sending unit location
Could use a drawing / schematic to help expedite replacement of the oil pressure sending unit (showing exactly where the bugger resides).
Have the $ 9 replacement part (dealer wanted $ 125 to do the job) just need to locate it...
A response ASAP would be appreciated.
Have the $ 9 replacement part (dealer wanted $ 125 to do the job) just need to locate it...
A response ASAP would be appreciated.
Joined: Jul 2006
Posts: 834
From:
RE: '89 Bronco II oil pressure sending unit location
If it is a 2.9 here you go [hr]Under hood, driver side, lower engine area, beneath exhaust manifold, left side of oil level sender, above oil pan rail, mounted in block.[hr]As Per Autozone
Thread Starter
Joined: Sep 2006
Posts: 2
RE: '89 Bronco II oil pressure sending unit location
First, 94 4x4 ranger, my apologies for not responding until now (been a little busy with other responsibilities).
Yes, it is a 2.9 and I thank you for the word picture, however (being a visual learner), before I climb underneath to do the deed, would you (or anyone else reading this) be able to provide a drawing (embed picture in post) just to make sure I don't cause myself any avoidable mechanical grief?
Yes, it is a 2.9 and I thank you for the word picture, however (being a visual learner), before I climb underneath to do the deed, would you (or anyone else reading this) be able to provide a drawing (embed picture in post) just to make sure I don't cause myself any avoidable mechanical grief?
Thread
Thread Starter
Forum
Replies
Last Post
