Hi All,

I am replacing a Hatch on my 2010 Escape XLT with one from a 2008 Escape Limited.
The hatch handle is in a different location, does that change any of the wiring in any way?
I am in the middle of swapping harnesses and am seeing an obvious difference with regards the lower handle on the 2010.
Will I need to reroute any wires to make this change work or are there any wires that become obsolete?
Any information would be appreciated. If there are any diagrams that are available, I would appreciate them too.
I also have wiring pieces from the 2008 that may be used in this process if necessary.

Thanks for your time and assistance.


Best Regards,
70Eliminator