Looking for some help. Just replaced blend door actuator
#1
Looking for some help. Just replaced blend door actuator
I just replaced the blend door actuator in my wife's 2003 explorer xlt. We purchased this past winter and it was clicking when I would change from heat to a/c. So I replaced actuator and there us no clicking but it is blowing out hot air only. I charged the freon and no change at all. Is there a fuse? Relay? Any help is appreciated. It's in the 90s and high humidity here lol
#2
The first thing we need to know is , do you hear or see the air conditioning compressor clutch engaging the compressor when air cond is selected? There are both fuses and relays involved with the A/C system. If you look in the fuse section of your owner's manual it will list for you the fuse that is provided for air cond power supply.
I reread your post and normally you can't add refrigerant unless the compressor clutch engages the compressor. So,,,, that means it is either working or you only think you added refrigerant. Could you please clarify? Thanks
I reread your post and normally you can't add refrigerant unless the compressor clutch engages the compressor. So,,,, that means it is either working or you only think you added refrigerant. Could you please clarify? Thanks
Last edited by hanky; 07-01-2014 at 01:50 PM.
#5
I just replaced the blend door actuator in my wife's 2003 explorer xlt. We purchased this past winter and it was clicking when I would change from heat to a/c. So I replaced actuator and there us no clicking but it is blowing out hot air only. I charged the freon and no change at all. Is there a fuse? Relay? Any help is appreciated. It's in the 90s and high humidity here lol
Thread
Thread Starter
Forum
Replies
Last Post
makuloco2000
Ford F-150
0
10-03-2014 07:38 PM
cubuffs
Windstar/Aerostar
0
03-23-2008 12:22 PM