Readiness Monitors
Thread Starter
|
Junior Member
Joined: Jan 2017
Posts: 5
Readiness Monitors
I have a 2007 Mercury Milan - 3.0 V6
Recently replaced cat and cleared P0420 Cat Efficiency Below Threshold Bank 1 error.
Need inspection.
How long does it take for the Readiness Monitors related to this error to reset?
Is there anything that I can do to speed the process along?
My state, Missouri, requires 1 related incomplete can remain and still pass emissions.
More that one incomplete disallows passing emissions.
Recently replaced cat and cleared P0420 Cat Efficiency Below Threshold Bank 1 error.
Need inspection.
How long does it take for the Readiness Monitors related to this error to reset?
Is there anything that I can do to speed the process along?
My state, Missouri, requires 1 related incomplete can remain and still pass emissions.
More that one incomplete disallows passing emissions.
Senior Member
Joined: Jun 2010
Posts: 16,528
That particular monitor will usually run with some city driving and some highway driving.Just make sure to do both for a few miles to allow the monitors to run.
Side note;
As long as certain other monitors were able to "Pass" the catalyst monitor should run without any problem.
Side note;
As long as certain other monitors were able to "Pass" the catalyst monitor should run without any problem.
Super Moderator
Joined: Jul 2006
Posts: 7,555
The monitors can be forced to complete within 'specific' detailed drive cycles being met. Depending on your drive length/miles, conditions needed during, generally a few days +/-. That said, if a forced attempt, it helps to have a copilot reading you the drive commands or details otherwise dicey to do both. If your in a rush, I can copy the drive strategy and post it, or email it...
Last edited by Hayapower; Feb 6, 2017 at 10:17 PM.
Thread
Thread Starter
Forum
Replies
Last Post
