When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
The 1955 and 1956 FYB flex-plate was replaced by the 1957 flex-plate, B7A 6375-A for service, The 1957 flex-plate includes three reinforcement rings (B9AZ 6A366-A). I cannot find any service info as to how theses rings are placed.
Does anyone know or have the service information as how the flex-plate and rings are assembled in correct sequence to the crank flange?
Welcome to the site..
Cant answer the question, but is the old flex still installed?
If so, I’d take a measurement and set the new unit at the same face spec..
Welcome to the site.
.
Cant answer the question, but is the old flex still installed?
If so, I’d take a measurement and set the new unit at the same face spec..
THANX!! for the welcome.
No, I don't actually have one, but the info is not within the '57 SHOP or TRANS MANUAL. Most likely the details were included in a SERVICE LETTER of the period.
Sorta like my sex life, one disappointment after another ...
06-22-2019, 01:20 PM
F/m - 1955-56-57
