2002 E150 Transmission Fluid Capacity
Junior Member
Joined: Sep 2024
Posts: 1
trans drain and fill
Hi Hanky, thanks so much for the quick and helpful reply. That clears up a lot. I just bought my van at around 180k miles. Do you think I should drain the converter, or is that not necessary? This would be my first transmission fluid change. I had planned only to do the pan and filter. Not sure how I would drain the converter.
One more question, if I wanted to replace more of the fluid, could I just do two fluid changes? What would this process be like? Do I have to start the van between pan removals?
This is what I'm imagining for two replacements:
1. Remove drain pan to empty old fluid.
2. Replace drain pan.
3. Add new fluid to replace lost fluid.
4. Remove drain pan to empty old fluid.
5. Replace gasket and filter.
6. Replace drain pan.
7. Add new fluid to replace lost fluid.
Am I on the right track?
Lastly, is it even a good idea to replace more of the fluid?
One more question, if I wanted to replace more of the fluid, could I just do two fluid changes? What would this process be like? Do I have to start the van between pan removals?
This is what I'm imagining for two replacements:
1. Remove drain pan to empty old fluid.
2. Replace drain pan.
3. Add new fluid to replace lost fluid.
4. Remove drain pan to empty old fluid.
5. Replace gasket and filter.
6. Replace drain pan.
7. Add new fluid to replace lost fluid.
Am I on the right track?
Lastly, is it even a good idea to replace more of the fluid?
start it up and let it Idle a bit, I like to have someone else at the key to stop it as soon as fluid flow reduces.
now I pull the pan and change the filter and clean the pan up.
replace the pan and add about 5 quarts.
start it back up and let about 4 quarts come out.
stop and add 4 quarts.
repeat until you see clean fluid coming out.
you have now allowed the trans pump to push out all the old fluid through the converter and the cooler.
once you have seen the clean fluid stop and put the line from the cooler back in place and add fluid until it is at the correct level, should be idling and at temp when you make the final check.
Thread
Thread Starter
Forum
Replies
Last Post
