I have been searching I-Net on how to remove my radio from my 2006 F150. It does not have the "holes" in front like my 2000 model. Any ideas?

 

Welcome....

Sent you an email...

 

Thanks.. our e-mail server is down right now. I will check out e-mail when they get server fixed

 

Finish panel clips/snaps to the dash.. Pull evenly/outward to remove.. Also included an exploded view for clarity...

Removal and Installation.
[ol][*]Remove the center instrument panel finish panel.[*]Disconnect the electrical connectors.
[ul][/ul][/ol][*]Remove the 4 screws and the audio unit.[*]Disconnect the electrical connectors and the antenna lead.
[ul][/ul]
[ol][/ol][*]To install, reverse the removal procedure
[ol][/ol]


[IMG]local://upfiles/6756/EE1B12E5E52D44F69DAA1B194EBD8775.gif[/IMG]

[IMG]local://upfiles/6756/DD451CC428FE4E55865F264987415FE6.gif[/IMG]

 

Are you saying that the cover plate just snaps off with no tools needed?

 

The finish panel just snaps on.. It helps sometimes to use a flat edge/hook typepuller to help get behind the panel, more so if you can keep it in the area of the clips.. If you refer to the 'exploded view' (#12)of the dash/panel you can see the clip 'tabs' anchor points,pointing towards the dash slots

 

Appreciate.. will give it a try over weekend. I want to see if I have an audio out jack on back of radio

 

Think there's only the three connectors and the antenna lead.. What are you trying to add in or on?

 

I am very curios about this question, since i am trying to add an ipod hook directly to the factory stereo, can you send me any information on how to remove the radio so i can get to the back of it? Thanks

 

Same MY/Application?

The instructions were in the 4th post .. Also, if your adding an ipod, you might want to concider a interface adapter from PIE (Precision Interface Electronics).. http://www.pie.net/Plug'n play connection..