My turn signal switch connector is loose. When I lower my steering wheel the blinkers will not work. I took the shroud off and can hold the gray switch connector in place and it seems to work but the wires in it seem loose. Can I replace just that connector or do you have to replace all the wires to? Thanks...

 

If you carefully unplug the plug you should be able to see the locking tabs on each wire terminal. It would pay to make sure that the problem is with the wire terminals in the plug before looking to replace it. There should be a locking tab on the sides of the plug that hold it in place . Make sure they are holding it in place when pressed all the way on.