2000 E250 Brake issues.
#1
2000 E250 Brake issues.
While driving a while back I was applying the brakes and hit a small pot hole and my brakes went to the floor. No matter how many times I pumped them they still wouldn't hold. I managed to get the van home and the next day the brakes were fine. A couple of months later the same thing occured (applying the brakes and hitting a bump) this time the problem has hasn't gone away. I bled the brakes with a pneumatic bleeder and the only change is if I pump the brakes 3 or 4 times I have good pedal but the next time I apply the brakes they go to the floor. It stops fine with the little pedal I have but obviously there's a problem. Any ideas?
#2
An idea, among a few,
Maybe, a questionable wheel bearing or loose connection at a wheel speed sensor allowing loss of the wheel speed sensor signal leading the ABS to think a wheel is locking up and dumping the hydraulic pressure. See if there are any codes in the system to help provide some direction.
Maybe, a questionable wheel bearing or loose connection at a wheel speed sensor allowing loss of the wheel speed sensor signal leading the ABS to think a wheel is locking up and dumping the hydraulic pressure. See if there are any codes in the system to help provide some direction.
Thread
Thread Starter
Forum
Replies
Last Post
LOVES VANS
Ford Econoline E Series
2
05-05-2015 05:04 PM