How do you remove the EGR valve in a 96 5.8?
#2
Its been a while since I last did one of those. Its a stinker , but be careful they are rusted in pretty well. Soak it first with Liq wrench or bb blaster. Wd 40 is not that good.
The large nut on the bottom if I recall correctly is difficult to get at also. Patience pays.
The large nut on the bottom if I recall correctly is difficult to get at also. Patience pays.
#3
Its been a while since I last did one of those. Its a stinker , but be careful they are rusted in pretty well. Soak it first with Liq wrench or bb blaster. Wd 40 is not that good.
The large nut on the bottom if I recall correctly is difficult to get at also. Patience pays.
The large nut on the bottom if I recall correctly is difficult to get at also. Patience pays.
Thread
Thread Starter
Forum
Replies
Last Post
bighank
Ford F-250 & Ford F-350
1
06-08-2013 06:09 PM
JayKay
Ford Thunderbird
0
03-20-2010 03:08 PM