Revers lights switch
Super Moderator
Joined: Jul 2006
Posts: 7,555
Scott..
That part number imaged is a trans controller/module. I’d think it would control range/lamp function like the MLPS..
Ive had issues pasting in the past from PTS. When published, the script blocking changes as does the numeric arrangement. Haven’t seen them all go to 1, but I’ll check it out.
(Tried it as well, same result.)
So,, when select/copy/paste from PTS, the numerical arrangement isn't included/highlighted in the captured data. Although, numerically is does show up on initial paste on a reply, lost when published.. Not sure if there's a way around it other than an edit/change within this site. I'll look further into it..
That part number imaged is a trans controller/module. I’d think it would control range/lamp function like the MLPS..
Ive had issues pasting in the past from PTS. When published, the script blocking changes as does the numeric arrangement. Haven’t seen them all go to 1, but I’ll check it out.
(Tried it as well, same result.)
So,, when select/copy/paste from PTS, the numerical arrangement isn't included/highlighted in the captured data. Although, numerically is does show up on initial paste on a reply, lost when published.. Not sure if there's a way around it other than an edit/change within this site. I'll look further into it..
Last edited by Hayapower; Jul 12, 2020 at 02:40 PM.
Thread
Thread Starter
Forum
Replies
Last Post